The 4N0616005C air suspension compressor pump is an OEM-spec replacement part designed for the 2017–2022 Audi A8 (D5/4N chassis) and manufactured by Wabco. This compressor supplies compressed air to the four-wheel air suspension system, enabling ride height adjustment and load compensation. As a brand new single pump, it is compatible with most engine configurations on the D5 platform and effectively resolves issues such as suspension sagging and abnormal ride height caused by compressor aging. Replacing the relay at the same time is recommended to ensure stable system operation.
| Product Name | Air Suspension Compressor Pump (Single Pump) |
|---|---|
| OE Number | 4N0616005C |
| Brand | Wabco |
| Vehicle Application | Audi A8 D5/4N (2017–2022) |
| Chassis | 4N |
| Voltage | 12V |
| Type | Single pump |
This product is compatible with the following Audi A8 (D5/4N) models:
The Audi D5 platform compressor is available under multiple OE numbers (4N0616005, 4N0616005B/C/D/E, etc.). This product is a single pump from the 4N0616005C series. Please verify your original compressor OE number before purchase. The relay must be replaced at the same time during installation; otherwise, the new compressor may fail prematurely.
This product is a direct replacement for the following OEM part numbers:
Keep dry, clean, and handle with care.
Land Rover air suspension compressor pump warehouse storage and handling
Think Global, Act Local. Proven Worldwide.
Global exhibitions showcasing Land Rover air suspension components
A: Common symptoms include: vehicle sagging after parking; inability to adjust ride height or slow raising/lowering; compressor running continuously or not operating at all, accompanied by abnormal noise; suspension fault warnings on the dashboard. It is recommended to use a diagnostic tool to read fault codes for confirmation and to check the air springs and lines for leaks. System leaks cause the compressor to run continuously and overheat — always rule out leak points before replacing the compressor.
A: The relay is a wear item, and its contacts may stick after prolonged use. If the relay sticks, the compressor may run continuously when the system does not require it, leading to overheating and burnout. Most manufacturers explicitly require replacing the relay when replacing the compressor; otherwise, the warranty may be affected. It is recommended to replace it at the same time during installation to avoid secondary damage to the new compressor in the short term.
A: The single pump includes only the pump body, suitable for cases where the dryer is in good condition and only the pump body has failed. The assembly includes the dryer, relay, and other accessories, suitable for scenarios where the system has aged comprehensively. If your original compressor has been in use for more than 5 years or the dryer is saturated, it is recommended to choose the assembly version to avoid secondary repairs in the short term. After installation, a diagnostic tool must be used to perform inflation/deflation tests and clear any fault codes.
Contact Us at Any Time