The 4Z7616007A air suspension compressor pump is an OEM-spec replacement part specifically designed for the 2001–2005 Audi A6 C5/4B Allroad quattro models, manufactured by Wabco. This compressor supplies compressed air to the four-wheel air suspension system, enabling ride height adjustment and load compensation. As a brand new single pump with an integrated dryer design, it effectively resolves issues such as suspension sagging and abnormal ride height caused by compressor aging.
| Product Name | Air Suspension Compressor Pump (Single Pump) |
|---|---|
| OE Number | 4Z7616007A |
| Brand | Wabco |
| Vehicle Application | Audi A6 C5/4B Allroad (2001–2005) |
| Voltage | 12V (DC 13V) |
| Operating Pressure | Approx. 20 bar |
| Type | Single pump (with integrated dryer) |
| Operating Temperature | -30°C to 80°C |
This product is compatible with the following Audi models:
⚠️ Important Note: This product is ONLY suitable for Allroad quattro models equipped with air suspension and is NOT compatible with standard coil spring A6 models. Please verify that your original compressor OE number is 4Z7616007A or 4Z7616007 before purchase. It is recommended to replace the relay at the same time during installation to prevent premature failure of the new compressor caused by stuck contacts in the old relay.
This product is a direct replacement for the following OEM part numbers:
Keep dry, clean, and handle with care.
Land Rover air suspension compressor pump warehouse storage and handling
Think Global, Act Local. Proven Worldwide.
Global exhibitions showcasing Land Rover air suspension components
A: Common symptoms include: vehicle sagging at one side or all four corners after parking; suspension fault warnings on the dashboard; compressor running continuously or not operating at all.
Note: Compressor failure on the C5 Allroad is often triggered by air spring leaks — leaks cause the compressor to run frequently and overheat until it burns out. Before replacing the compressor, always check the air springs and lines for leaks; otherwise, the new compressor may fail again in the short term.
A: The relay is a common failure point in the C5 Allroad air suspension system. After prolonged use, the contacts may stick or burn, causing the compressor to either not operate or run continuously. If only the compressor is replaced without replacing the relay, a faulty old relay may directly damage the new compressor. It is recommended to replace the relay at the same time during installation (OE reference: 8D0951253A / 4H0951253A).
A: The single pump includes only the compressor unit (with integrated dryer), suitable for cases where the relay is in good condition and only the pump body has failed. The kit with relay additionally includes a new relay, suitable for comprehensive system servicing or scenarios where the old relay has been in use for many years. Since the C5 Allroad has a relatively high relay failure rate, if your original relay has never been replaced, it is recommended to choose the version with relay to reduce the risk of secondary repairs. After installation, a diagnostic tool must be used to perform inflation/deflation tests and clear any fault codes.
Contact Us at Any Time