The 4L0698007 air suspension compressor assembly is designed for the 2005–2015 Audi Q7 (4L chassis) and manufactured by Wabco as an OEM-spec replacement part. It supplies compressed air to the four-wheel air suspension system, enabling ride height adjustment, suspension stiffness control, and load compensation, while working with the drive mode selection system to enhance comfort and handling stability.
This brand new assembly includes the pump body, dryer, relay, and mounting accessories, effectively resolving issues such as suspension sagging, abnormal ride height, and fault warnings caused by compressor aging.
| Parameter | Specification |
|---|---|
| Product Name | Air Suspension Compressor Assembly (with Dryer) |
| OE Number | 4L0698007 |
| Brand | Wabco |
| Vehicle Application | Audi Q7 4L (2005–2015) |
| Chassis | 4L |
| Voltage | 12V |
| Maximum Operating Pressure | Approx. 180 PSI |
| Included Components | Compressor pump body, dryer, relay, bracket, related accessories |
This product is compatible with the following Audi Q7 (4L) models:
⚠️ Important Note: The Audi Q7 4L air suspension is available in two configurations: air suspension version and coil spring version. This product is ONLY suitable for vehicles equipped with air suspension. Between 2005–2015, the compressor supplier for the 4L Q7 was Wabco — there are no AMK or Hitachi variants. The new generation Q7 (4M chassis) from 2015 onwards uses a different compressor specification — this product is NOT compatible. Please verify that your vehicle is equipped with air suspension and a compressor before purchase.
This product is a direct replacement for the following OEM part numbers:
Keep dry, clean and handle with care.
Land Rover air suspension compressor pump warehouse storage and handling
Think Global, Act Local. Proven Worldwide.
Global exhibitions showcasing Land Rover air suspension components
A: Common symptoms include: noticeable sagging at one corner or all four corners after parking; inability to adjust ride height while driving or slow raising/lowering (e.g., unable to switch to off-road raise mode or dynamic lower mode); abnormal compressor noise, continuous running, or complete failure to operate; "Air Suspension Fault" or "Chassis System Fault" warnings on the dashboard; vehicle stuck at minimum height and unable to rise. If any of these occur, it is recommended to use a professional diagnostic tool (such as VCDS or ODIS) to read fault codes for accurate fault localization as soon as possible.
A: The assembly includes the pump body, a brand new dryer, relay, and all mounting accessories — ideal for scenarios where the dryer has aged or for comprehensive system repairs, offering a one-stop replacement solution. The single pump includes only the compressor pump body — suitable for cases where the dryer is in good condition and only the pump body has failed, at a lower replacement cost. Since the desiccant inside the dryer becomes saturated with moisture over time, if your original unit has been in use for more than 5 years or you are experiencing suspension faults, it is recommended to choose the assembly version to avoid premature compressor failure caused by a degraded dryer in the short term.
A: Pay special attention to the following four points: First, confirm that your vehicle is equipped with air suspension before installation — this product is NOT compatible with coil spring versions; Second, the relay must be replaced at the same time (supplied with this unit) — failure to do so may cause premature compressor failure; Third, after installation, a professional diagnostic tool (such as VCDS or ODIS) must be used to perform suspension system inflation and deflation tests and clear any fault codes; Fourth, during the first run after installation, observe whether the compressor operates as required and check all air line connections for leaks. Professional installation by a technician with Audi service experience is recommended.
Contact Us at Any Time