The 4F0616005F air suspension compressor pump is an OEM-spec replacement part designed for the 2004–2011 Audi A6 (C6/4F chassis, including Allroad quattro, Avant, and S6), manufactured by Wabco. This compressor supplies compressed air to the four-wheel air suspension system, enabling ride height adjustment and load compensation. As a brand new single pump, it fits most air suspension configurations on the C6 platform and effectively resolves issues such as suspension sagging and abnormal ride height caused by compressor aging.
| Parameter | Specification |
|---|---|
| Product Name | Air Suspension Compressor Pump (Single Pump) |
| OE Number | 4F0616005F |
| Brand | Wabco |
| Vehicle Application | Audi A6 C6/4F (2004–2011) |
| Voltage | 12V |
| Type | Single pump |
| Wabco Number | 4154039582 |
This product is compatible with the following Audi A6 (C6/4F) models:
⚠️ Important Note: This product is ONLY suitable for C6 models equipped with air suspension. Standard coil spring A6 models are NOT compatible. Please verify that your original compressor OE number is from the 4F0616005F series before purchase. It is recommended to replace the relay at the same time during installation; otherwise, the new compressor may fail prematurely.
This product is a direct replacement for the following OEM part numbers:
Keep dry, clean, and handle with care.
Land Rover air suspension compressor pump warehouse storage and handling
Think Global, Act Local. Proven Worldwide.
Global exhibitions showcasing Land Rover air suspension components
A: Common symptoms include: vehicle sagging at one side or all four corners after parking; air suspension fault warnings on the dashboard; compressor running continuously or not operating at all, accompanied by abnormal noise. It is recommended to use a diagnostic tool to read fault codes and to check the air springs and lines for leaks first — leaks cause the compressor to run frequently and overheat until it burns out. Always resolve any leak points before replacing the compressor.
A: The relay is a common failure point in the C6 air suspension system. Old relay contacts may stick or burn, causing the compressor to either not operate or run continuously. If only the compressor is replaced without replacing the relay, a faulty old relay may directly damage the new compressor. Most manufacturers explicitly require replacing the relay when replacing the compressor; otherwise, the warranty may be affected.
A: The single pump includes only the pump body (with integrated dryer), suitable for cases where the relay is in good condition and only the pump body has failed. The assembly typically includes a new relay and installation accessories, suitable for comprehensive system servicing or scenarios where the old relay has been in use for many years. Since the C6 has a relatively high relay failure rate, if your original relay has never been replaced, it is recommended to choose the version with relay to reduce the risk of secondary repairs. After installation, a diagnostic tool must be used to perform inflation/deflation tests and clear any fault codes.
Contact Us at Any Time