The 3D0616007D air suspension compressor is an OEM-spec replacement part designed for the 2001–2016 Volkswagen Phaeton (3D chassis) and select Bentley Continental GT / Flying Spur models, manufactured by Wabco. This compressor supplies compressed air to the four-wheel air suspension system, enabling ride height adjustment and load compensation to ensure flagship-level ride comfort. It fits all air suspension configurations on the Phaeton and effectively resolves issues such as suspension sagging and abnormal ride height caused by compressor aging.
| Product Name | Air Suspension Compressor |
|---|---|
| OE Number | 3D0616007D |
| Brand | Wabco |
| Vehicle Application | VW Phaeton 3D (2001–2016) |
| Voltage | 12V |
| Type | Compressor (with dryer) |
| Wabco Number | 4154031060 |
This product is compatible with the following models:
⚠️ Important Note: The Phaeton comes standard with four-wheel air suspension, and this product is designed for 3D chassis models. Please verify that your original compressor OE number is from the 3D0616007D series before purchase. It is recommended to replace the relay at the same time during installation; otherwise, the new compressor may fail prematurely.
This product is a direct replacement for the following OEM part numbers:
Keep dry, clean, and handle with care.
Think Global, Act Local. Proven Worldwide.
Common symptoms include: vehicle sagging at one side or all four corners after parking; suspension fault warnings on the dashboard; compressor running continuously or not operating at all.
Note: Compressor failure on the Phaeton is often triggered by air spring or valve block leaks — leaks cause the compressor to run frequently and overheat until it burns out. Before replacing the compressor, always check for leak points; otherwise, the new compressor may fail again in the short term. It is recommended to use a diagnostic tool to read fault codes and check system pressure retention.
The relay is a common failure point in the Phaeton air suspension system. After prolonged use, the contacts may stick or burn, causing the compressor to either not operate or run continuously. If only the compressor is replaced without replacing the relay, a faulty old relay may directly damage the new compressor. It is recommended to replace the relay at the same time during installation to avoid secondary repairs.
Select early model years of the Bentley Continental GT (approximately 2003–2010) share the 3D platform chassis and air suspension components with the Phaeton, and can use the 3D0616007D series compressor. However, due to configuration differences across Bentley model years, be sure to verify your original compressor OE number and confirm it matches this product before installation. It is recommended to confirm compatibility by VIN query.
Contact Us at Any Time